The current engraving machine can provide us with the convenience of engraving, and the numerical control operation mode gives us a fine engraving feature, so that any engraving requirements can be used in this new mechanical product. Achieve good product quality and achieve good operational results. However, we still need to do daily maintenance work for the engraving machine, so as to increase the utilization rate of the product, improve its performance, extend its service life, and let us get work efficiency.
When we work, we must pay attention to the continuous running time of the engraving machine for less than ten hours per day. We must keep the cooling water clean and the medium and long working conditions of the pump. The active main motor must not be out of water. It must be periodically. The replacement of the cooling water to cause the malfunction of the machine due to the high temperature of the waterproofing is also easy to bring us a safety hazard. In the winter, the cooling water must be replaced with antifreeze, so that we can change our working environment, bring us good use conditions, improve our work efficiency and ensure the best performance of the machine.
After each use of the machine, pay attention to the cleaning of various parts, and ensure that the plane table and the transmission system are clean and tidy. At the same time, it is necessary to carry out the temperature lubrication of the y-axis z-axis x-axis. When the machine is not working, the power must be cut off. The machine is used for about three months, and the fastening of various parts is checked. Only good maintenance can bring us a smooth working environment. For the wood engraving machine stone engraving machine, it is also necessary to do the maintenance work, so that it can bring us good work efficiency in our different engraving production, and also bring us good work quality. .
